Sloped Fence Post, Picket & Gate Calculator
Lay out 4ft, 6ft, or 8ft wood privacy, board-on-board, and chain-link runs across flat, stepped, or raked yard grades with automatic gate framing and concrete post bag totals.
Calculate wood privacy, board-on-board, and chain-link fence posts, rails, pickets, walk/drive gates, and stepped vs. raked yard slope panels with a 2D elevation drawing.
Frequently Asked Questions
Should I build a stepped fence or a raked fence on a sloped yard?
Use stepped (stair-step) panels on gentle-to-moderate grades up to roughly 6 to 8 inches of drop per 8-foot bay when using solid wood privacy pickets, keeping picket tops level. Switch to raked (contoured) rails on steeper hills or aluminum/chain-link runs so the bottom rail follows the ground line without leaving large triangular pet gaps.
How deep should 4×4 or 4×6 wood fence posts be set in concrete?
Set fence posts at least one-third to one-half of the above-ground fence height—typically 30 to 36 inches deep for a 6-foot privacy fence, or 6 inches below the local frost line in cold climates—resting on 4 inches of drainage gravel with 1.5 to 2 bags of concrete per post hole.
When should fence post spacing drop from 8 feet on-center to 6 feet on-center?
Standard 6-foot residential wood fences use 8-foot on-center post spacing on sheltered lots. Drop post spacing to 6 feet on-center for 8-foot-tall privacy fences, board-on-board heavy wind zones, or sandy soils to prevent 2×4 horizontal rails from sagging and posts from leaning.
How many 5.5-inch wood fence pickets do I need per 8-foot section?
For standard side-by-side butt-joint privacy fencing using nominal 1×6 (actual 5.5-inch wide) dog-ear pickets, divide 96 inches by 5.5 inches to get 17.45 pickets per 8-foot bay before waste. For overlapping board-on-board privacy fences with a 1.5-inch overlap, plan on approximately 24 to 26 pickets per 8-foot section.
Why do gate hinge posts require heavier lumber and extra concrete?
Walk gates and double drive gates exert continuous cantilevered torque on the hinge post. Upgrading gate posts to 4×6 or 6×6 pressure-treated timbers set 36+ inches deep with 3 bags of concrete prevents gate latch misalignment after seasonal freeze-thaw cycles.